To create the tag, I used the new 123 Punch Board, an angle Corner Chomper, and the trim and score board (links below).
To start, I cut the pocket portion of my tag from navy card stock 3 1/2” x 10”, and scored the piece at 5”.
Next, I created a notch on one short side of the card stock for my “shirt collar” by using the center marks on the 123 Punch Board. Then I adhered the piece together on the long sides to create a pocket, and punched a small round hole in the back to hold my jute cord.
I cut a piece of plaid paper (from the StoryTime collection) to create my shirt. 3 1/4” x 4 3/4”. I followed the same steps to create the tag corners and “shirt collar” notch.
Finally, I added the bow tie to the front of the “shirt” and then added a few buttons and a title.